The procedures in this section address the following minimum configuration requirements necessary on the Unified CM for Cisco Jabber for Windows support. For minimum software requirements for the Unified CM, CUPS, and Cisco Jabber for Windows, see the applicable Release Notes for the Cisco TelePresence Exchange System, at. The procedures in this section assume that the Cisco Unified Communications Manager (Unified CM), Cisco Unified Presence Server (CUPS), and Cisco Jabber for Windows are already installed and active in the network. Cisco Jabber Video for TelePresence Enterprise for iPad in VCS Mode Cisco Jabber for Windows in Unified CM Mode.Cisco Jabber for iPad in Unified CM Mode.Cisco Jabber for Windows in Unified CM Mode.The procedures in this chapter address the minimum configuration requirements necessary on the Cisco Unified Communications Manager (Unified CM) and Cisco TelePresence Video Communication Server (VCS) to support the following Cisco Jabber clients: IP Communications Required by the Cisco TelePresence Exchange System.Organization Bandwidth, Endpoint Capacity, Protocols and Bridge Selection.Troubleshooting the Cisco TelePresence Exchange System.Maintaining the Cisco TelePresence Exchange System.Configuring Internet Group Management Protocol for Multicast Support.Configuring Cisco TelePresence MSE 8000 Series.Configuring Cisco Session Border Controllers.Configuring Cisco Unified Communications Manager.Configuring the Cisco TelePresence Multipoint Switch.Configuring the Cisco Application Control Engine.Configuring External Network Components for the Cisco TelePresence Exchange System.Configuring the Cisco TelePresence Exchange System.Installing the Cisco TelePresence Exchange System. Overview of the Cisco TelePresence Exchange System.
0 Comments
Leave a Reply. |